JLG 4394RT - Radiator; Radiator (Deutz Engine)

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3-62 – JLG Lift – 3121642
Radiator
ALLOW RADIATOR TO COOL DOWN BEFORE SERVICING.
REMOVAL:
1. Disable machine operation.
1. Drain the coolant from the radiator into a suitable con-
trainer by opening the petcock on the bottom left cor-
ner of the radiator.
2. Disconnect the:
- upper and lower radiator hoses
- hoses from the overflow tank
- temp sensor connector from overflow tank
- if necessary remove the air cleaner or disconnect the
intake pipe hose connector at the radiator mounting
plate
3. Support the radiator mounting plate assembly and
remove the four (4) large bolts holding the mounting
plate to the engine swivel tray.
4. Re-check that all connections, hoses, etc. are discon-
nected and remove complete radiator mounting plate
assembly from the engine tray.
5. Dissemble the radiator shroud, and radiator assembly
from the radiator mounting plate assembly.
INSTALLATION:
1. Follow Removal Steps in reverse.
Figure 3-67. Radiator (Deutz Engine)
1. Radiator Mounting Plate
2. Radiator Assembly
3. Fan Shroud Assembly
4. Engine Tray