SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3-14 – JLG Lift – 3121642
3. Apply a light coat of "Never-Seize" to two pipe plugs (1J)
and tighten them into the two pipe plug holes in the
side of the hub (1G).
NOTE: Make sure the cup sits square with the counterbore before
pressing.
4. Turn hub (1G) over onto its small end. Press bearing cup
(1E) down into the counterbore in the deep end of the
hub (1G).
5. Set hub (1G) onto its large end. Place bearing cone (1D)
into bearing cup (1C).
6. Press seal (1B) into the small end of hub (1G).
7. Oil spindle, then lower hub (1G), small end down, onto
spindle (1A).
8. Press bearing cone (1F) onto spindle (1A) in hub (1G).
To Next Page
Loading...
