Juniper BGP - CONFIGURATION GUIDE V 11.1.X User Manual

Behavior is different for outbound policies configured for peer groups for which
you have enabled Adj-RIBs-Out. If you change the outbound policy for such a
peer group and want to fill the Adj-RIBs-Out table for that peer group with the
results of the new policy, you must use the clear ip bgp peer-group command
to perform a hard clear or outbound soft clear of the peer group. You cannot
merely perform a hard clear or outbound soft clear for individual peer group
members because that causes BGP to resend only the contents of the Adj-RIBs-Out
table.
■ Use the no version to disassociate the access list from a neighbor.
■ See neighbor distribute-list.
neighbor prefix-list
■ Use to assign an inbound or outbound prefix list.
■ If you specify a BGP peer group by using the peerGroupName argument, all the
members of the peer group inherit the characteristic configured with this
command unless it is overridden for a specific peer. However, you cannot
configure a member of a peer group to override the inherited peer group
characteristic for outbound policy.
■ Example
host1(config-router)#neighbor 192.168.1.158 prefix-list seoul19 in
■ New policy values are applied to all routes that are sent (outbound policy) or
received (inbound policy) after you issue the command.
To apply the new policy to routes that are already present in the BGP routing
table, you must use the clear ip bgp command to perform a soft clear or hard
clear of the current BGP session.
Behavior is different for outbound policies configured for peer groups for which
you have enabled Adj-RIBs-Out. If you change the outbound policy for such a
peer group and want to fill the Adj-RIBs-Out table for that peer group with the
results of the new policy, you must use the clear ip bgp peer-group command
to perform a hard clear or outbound soft clear of the peer group. You cannot
merely perform a hard clear or outbound soft clear for individual peer group
members because that causes BGP to resend only the contents of the Adj-RIBs-Out
table.
■ Use the no version to remove the prefix list.
■ See neighbor prefix-list.
neighbor prefix-tree
■ Use to assign an inbound or outbound prefix tree.
■ If you specify a BGP peer group by using the peerGroupName argument, all the
members of the peer group inherit the characteristic configured with this
command unless it is overridden for a specific peer. However, you cannot
configure a member of a peer group to override the inherited peer group
characteristic for outbound policy.
■ Example
86 ■ Configuring BGP Routing Policy
JUNOSe 11.1.x BGP and MPLS Configuration Guide

Juniper BGP - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	BGP - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English