Juniper BGP - CONFIGURATION GUIDE V 11.1.X

OutDiscards: 0
1 interface(s) found
host2#show atm subinterface atm 4/0.101
Circuit Interface
Interface ATM-Prot VCD VPI VCI Type Encap MTU Status Type
--------- -------- --- --- --- ------- ----- ---- -------------- ---------
ATM 4/0.101 ATM/MPLS 101 0 101 PVC AAL0 9180 lowerLayerDown Static
Maximum number of cells per packet: 150
Cell aggregation timeout timer: 3
SNMP trap link-status: disabled
InPackets: 0
InBytes: 0
OutPackets: 0
OutBytes: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
InPacketsUnknownProtocol: 0
OutDiscards: 0
1 interface(s) found
Related Topics ■ atm cell-packing
■ atm mcpt-timers
■ atm pvc
■ interface atm
■ interface loopback
■ ip address
■ mpls-relay
■ show atm mcpt-timers
■ show atm subinterface
Configuring HDLC Layer 2 Services
The following commands configure an HDLC layer 2 circuit over MPLS between an
E Series router and a remote PE device.
To configure an HDLC layer 2 circuit over MPLS:
1. Configure a serial or POS interface on the ingress router.
host1(config)#interface serial 3/1:2/1
or
host1(config)#interface pos 4/0
538 ■ Configuring HDLC Layer 2 Services
JUNOSe 11.1.x BGP and MPLS Configuration Guide