Juniper BGP - CONFIGURATION GUIDE V 11.1.X

2. Configure the core-facing interface on which you want to enable MPLS, Label
Distribution Protocol (LDP), and topology-driven LSPs.
host1(config)#interface atm 5/0.100
host1(config-subif)#atm pvc 100 1 100 aal5snap 0 0 0
host1(config-subif)#ip address 192.168.5.5 255.255.255.0
3. Enable MPLS on the core-facing interface.
host1(config-subif)#mpls
4. Enable LDP and topology-driven LSPs on the core-facing interface.
host1(config-subif)#mpls ldp
host1(config-subif)#exit
Related Topics ■ Configuring MPLS on page 267
■ atm pvc
■ interface atm
■ ip address
■ mpls
■ mpls ldp
VPWS Configuration Example
The example in this section shows how to configure the VPWS topology illustrated
in Figure 134 on page 666. The example includes procedures for configuring VPWS
on both the local E Series router (PE 1) and the remote E Series router (PE 2).
Figure 134: Topology for VPWS Configuration Example
666 ■ VPWS Configuration Example
JUNOSe 11.1.x BGP and MPLS Configuration Guide