Table 59: show mpls rsvp hello instance Output Fields
Field DescriptionField Name
Address of the peer in the RSVP-TE hello adjacencyPeer Address
Specifier and status of each interfaceInterface
Identifies an RSVP-TE node hello peerany
Interval at which hellos are sent to the neighbor, in millisecondsInterval
Number of hello messages from the neighbor that can be missed
before the adjacency is considered to be down
Miss Limit
State of the adjacency with the neighbor:State
Adjacency has been lost. Hellos were received from the peer but
have timed out. The peer is known to be capable of graceful restart,
so the router is waiting for hellos to resume from the peer. The
router is actively sending hellos to the peer.
The router declares the peer to be dead if it does not receive hellos
from the peer during the peer’s advertised recovery period.
The router declares the peer to be gracefully restarting if hellos are
seen from the peer and its sequence number has changed.
The router declares the peer to be up if hellos are seen from the
peer and its sequence number has not changed.
AdjLost
Hellos were received from the peer but have timed out. The router
is not in graceful restart helper mode. The router changes the local
hello sequence number and does not send hellos to the peer. The
router transitions to Down if new control traffic needs to be sent
to the peer or if the peer starts sending control traffic.
Dead
No hellos have been received from the peer. The router is actively
sending hellos to the peer.
Down
Graceful restart in progress. The hello sequence number from the
peer changed. The router is in graceful restart helper mode and
actively sending hellos to the peer.
GR
Hellos were received from the peer. The router is actively sending
hellos to the peer.
Up
IP address of remote hello adjacency peerNeighbor
IP address of the local hello adjacency peerLocal Address
Graceful restart time, in millisecondsRestart Time
Graceful restart recovery time, in millisecondsRecovery Time
364 â– Monitoring RSVP-TE Hello Adjacency Instances
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Need help?
General
