host1#show l2vpn instance l2vpn1 detail
L2VPN: l2vpn1
Encapsulation Type ATM AAL5 SDU VCC transport
Use of control word is preferred
Send sequence numbers
Route Distinguisher 100:11
Site Range 10
Sites:
Site Name westford Site Id 1
Multi-homed: Yes
Site-Priority: 45
Route Targets:
Route Target: RT:100:2 both
Admin Oper
Interface Local-Site-Id Remote-Site-Id state state
---------- ------------- -------------- ------- -----
ATM2/0.100 1 2 enabled up
ATM2/0.12 1 3 enabled up
ATM1/1.1 1 2 enabled down
Meaning Table 108 on page 683 lists the show l2vpn instance command output fields.
Table 108: show l2vpn instance Output Fields
Field DescriptionField Name
Name of VPWS instanceL2VPN
Encapsulation type configured for the VPWS instanceEncapsulation Type
Local preference for control word, preferred or not preferredUse of control word
Local preference for sequence number, send or don’t sendsequence numbers
Route distinguisher configured for the VPWS instanceRoute Distinguisher
Maximum number of customer sites allowed in the L2VPN instanceSite Range
Site name and site ID for each customer site in the VPWS instanceSites
Status of the site. Yes designates a multihomed site. No designates
a site that is not multihomed.
Multi-homed
Priority value for the VPWS instance for the multihomed site;
displayed only when the value for the Multi-homed field is Yes
Site-Priority
Route targets configured for the VPWS instanceRoute Targets
Layer 2 interface that is a member of the VPWS instanceInterface
Local customer site ID configured on the layer 2 interfaceLocal-Site-Id
Remote customer site ID configured on the layer 2 interfaceRemote-Site-Id
Administrative state of the connection, disabled or enabledAdmin state
Operational state of the connection, up or downOper state
Monitoring VPWS Instances â– 683
Chapter 14: Monitoring VPWS
To Next Page
Loading...
Need help?
General
