Juniper BGP - CONFIGURATION GUIDE V 11.1.X User Manual

Table 73: show mpls interface and show mpls l2transport interface Output Fields
Field DescriptionField Name
Interface specifierMPLS shim interface
Address of the remote PE router for the layer 2 circuitRemote PE address
VC ID number for the interfaceVirtual circuit ID
Group ID number for the interfaceGroup ID
Configuration of the control wordControl word
Statement regarding configuration of sequence numberSequence number
Configuration of relay formatRelay format
Starting and ending (inclusive) virtual path identifiers and virtual
circuit identifiers of the reserved VC range and whether the range
specification is activated on the line module for transportation of
ATM cells that belong to multiple VCs over a single pseudowire.
ATM VPI/VCI range
Concatenation of multiple ATM cells to be sent in a single
MPLS-labeled packet for an ATM port, enabled or disabled.
ATM cell aggregation
Maximum number of ATM cells that the router can concatenate in
a single packet; if this value is not configured, "ATM cell
aggregation: disabled" appears instead of this field. Displayed for
an ATM port (ATM AAL5 over ATM major interface).
ATM cell aggregation
maximum cells per packet
Identifier (1, 2, or 3) of the ATM Martini cell packing timer that
detects timeout of the cell collection threshold; if this value is not
configured, "ATM cell aggregation: disabled" appears instead of
this field. Displayed for an ATM port (ATM AAL5 over ATM major
interface).
ATM cell aggregation
timeout timerID
Administrative state, enabled or disabledAdministrative state
Statement regarding operational state of interfaceOperational state
Maximum transmission unit for the interfaceOperational MTU
Statistics for MPLS traffic received or sent on the interfaceReceived, Sent
Number of packets received or sentpackets
Number of bytes received or sentbytes
Number of packets that are dropped for some reason at receipt or
before being sent
error
Number of packets that are discarded because of lack of buffer
space at receipt or before being sent
discards
MTU specified in received packetsreceived mtu
Queue and traffic class bound to the specified interfacequeue, traffic class, bound
to
570 ■ Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS
JUNOSe 11.1.x BGP and MPLS Configuration Guide

Juniper BGP - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	BGP - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English