Table 73: show mpls interface and show mpls l2transport interface Output Fields
(continued)
Field DescriptionField Name
Number of bytes in the queueQueue length
Total number of packets and bytes forwarded by this interfaceForwarded packets, bytes
Total number of committed packets and bytes dropped by this
interface
Dropped committed
packets, bytes
Total number of conformed packets and bytes dropped by this
interface
Dropped conformed
packets, bytes
Total number of exceeded packets and bytes dropped by this
interface
Dropped exceeded
packets, bytes
Type (input, output) and name of policyMPLS policy
Entry indexclassifier-group entry
Number of packets and bytes on the interfacepackets, bytes
Name of profilerate-limit-profile
Number of packets and bytes that conform to the committed access
rate
Committed
Number of packets and bytes that exceed the committed access
rate but conform to the peak access rate
Conformed
Number of packets and bytes that exceed the peak access rateExceeded
VC label sent by this router to upstream neighbor for routeIn label
VC label received by this router from downstream neighbor for
route
Out label
MPLS statistics for traffic received or sentMPLS statistics
Number of packets received or sentpkts
Number of high-capacity (64-bit) packets received or senthcPkts
Number of octets received or sentoctets
Number of high-capacity (64-bit) octets received or senthcOctets
Number of packets that are dropped for some reason at receipt or
before being sent
errors
Number of packets that are discarded because of lack of buffer
space at receipt or before being sent
discardPkts
Interface specifierInterface
IP address of the remote PE router or name of the tunnelRemote-PE or LSP-name
Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS â– 571
Chapter 8: Monitoring Layer 2 Services over MPLS
To Next Page
Loading...
Need help?
General
