Statistics are not stored in NVS. When enabled, the following statistics are maintained
for each policy:
■
EXP bits value
■
classifier group
■
packets and bytes
To disable collection of policy statistics for a specific MPLS tunnel:
■ Issue the no mpls statistics policy command.
host1#no mpls statistics policy tunnel5
Clearing and Re-Creating Dynamic Interfaces from MPLS Major Interfaces
To remove and re-create dynamic IPv4 interfaces and dynamic IPv6 interfaces from
all MPLS major interfaces or a specific MPLS major interface:
■ Issue the clear mpls dynamic-interfaces on-major-interfaces command:
host1#clear mpls dynamic-interfaces on-major-interfaces
You can use this command to reapply policies related to dynamic IPv4 and IPv6
interfaces on top of MPLS major interfaces.
There is no no version.
Related Topics ■ clear mpls dynamic-interfaces on-major-interfaces
Clearing and Refreshing IPv4 Dynamic Routes in the Tunnel Routing Table
To clear and then refresh a specified IPv4 dynamic route or all IPv4 dynamic routes
from the tunnel routing table of the virtual router or a specified VRF:
■ Issue the clear ip tunnel-routes command.
host1(config)#clear ip tunnel-routes *
There is no no version. This command takes effect immediately.
Related Topics ■ clear ip tunnel-routes
Clearing and Refreshing IPv6 Dynamic Routes in the Tunnel Routing Table
To clear and then refresh a specified IPv6 dynamic route or all IPv6 dynamic routes
from the tunnel routing table of the virtual router or a specified VRF.
Clearing and Re-Creating Dynamic Interfaces from MPLS Major Interfaces ■ 319
Chapter 4: Monitoring MPLS
To Next Page
Loading...