Related Topics â– show ldp igp-sync
Monitoring LDP Interfaces
Purpose Display information about all LDP interfaces or the specified LDP interface.
Action To display information about all LDP interfaces:
host1#show ldp interface
Interface ATM6/0.120
Interface address: 192.168.12.1/28
Enabled with profile 'default'
Configured hold time: 15
Hello interval: 5
Hold Time: 1
242 hello received, 242 hello sent, 0 hello rejected
1 adjacency created, 0 adjacency deleted,
Number of adjacencies = 1
Link hello adjacency: Address: 10.10.12.2, Transport address: 80.0.2.2,
Up for 00:20:09, Remaining hold time: 11 sec
To display brief information about LDP interfaces:
host1#show ldp interface brief
Interface IP-Address Protocol
ATM6/1.1 192.168.100.21/30 enabled
ATM6/1.3 192.168.100.17/30 enabled
ATM6/1.5 192.168.100.13/30 enabled
ATM6/0.7 172.16.100.1/30 enabled
ATM6/0.8 172.16.100.22/30 enabled
ATM6/0.9 172.16.100.14/30 enabled
NOTE: The mpls keyword is optional and is provided for compatibility with non–E
Series implementations.
Meaning Table 40 on page 330 lists the show ldp interface command output fields.
Table 40: show ldp interface Output Fields
Field DescriptionField Name
Identifier of the interfaceInterface
LDP has been autoconfigured on the interfaceautoconfigured
IP address of the interface, with address maskInterface address
Name of profile with which interface was enabledEnabled with profile
330 â– Monitoring LDP Interfaces
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
