Juniper BGP - CONFIGURATION GUIDE V 11.1.X User Manual

■ Tracing the Path of an MPLS Echo Request Packet to an RSVP-TE
Tunnel on page 369
■ Sending an MPLS Echo Request Packet to a VPLS Instance on page 369
■ Tracing the Path of an MPLS Echo Request Packet to a VPLS Instance on page 369
Sending an MPLS Echo Request Packet to an IP or IPv6 Address
To send an MPLS echo request packet to the specified IP or IPv6 address:
■ Issue the ping mpls command.
host1:pe1#ping mpls ip 10.2.2.2/32
Tracing the Path of an MPLS Echo Request Packet to an IP or IPv6 Address
To send MPLS echo request packets to discover and examine the path MPLS packets
follow to the specified IP or IPv6 address:
■ Issue the trace mpls ip command.
host1:pe1#trace mpls ip 192.168.25.1/32
Sending an MPLS Echo Request Packet to a Martini Circuit
To send an MPLS echo request packet to the specified layer 2 cross-connect virtual
(Martini) circuit:
■ Issue the ping mpls l2transport command.
host1:pe1#ping mpls l2transport FastEthernet1/0.1 detail
Tracing the Path of an MPLS Echo Request Packet to a Martini Circuit
To send MPLS echo request packets to discover and examine the path MPLS packets
follow to the specified layer 2 cross-connect virtual (Martini pseudowire) circuit:
■ Issue the trace mpls l2transport command.
host1:pe1#trace mpls l2transport FastEthernet1/0.1 detail
Sending an MPLS Echo Request Packet to an L3VPN IP or IPv6 Prefix
To send an MPLS echo request packet to the specified L3VPN IP or IPv6 prefix:
■ Issue the ping mpls l3vpn command.:
host1:pe1#ping mpls l3vpn vrf pe11 10.32.45.21/32
368 ■ Sending an MPLS Echo Request Packet to an IP or IPv6 Address
JUNOSe 11.1.x BGP and MPLS Configuration Guide

Juniper BGP - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	BGP - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English