Juniper BGP - CONFIGURATION GUIDE V 11.1.X

■ Monitoring LDP Targeted Hello Receive and Send Lists on page 337
■ Monitoring MPLS Status and Configuration on page 338
■ Monitoring MPLS Explicit Paths on page 341
■ Monitoring the RSVP-TE Bypass Tunnels on page 341
■ Monitoring MPLS Labels Used for Forwarding on page 342
■ Monitoring MPLS Interfaces on page 343
■ Monitoring MPLS Minor Interfaces on page 349
■ Monitoring MPLS Next Hops on page 351
■ Monitoring the Configured Mapping between PHB IDs and Traffic Class/Color
Combinations on page 352
■ Monitoring RSVP-TE Profiles and MPLS Tunnel Profiles on page 353
■ Monitoring RSVP Path State Control Blocks, Reservation State Control Blocks, or
Sessions on page 354
■ Monitoring RSVP MD5 Authentication on page 358
■ Monitoring RSVP-TE Interfaces Where BFD is Enabled on page 359
■ Monitoring RSVP-TE Interface Counters on page 360
■ Monitoring RSVP-TE Graceful Restart on page 362
■ Monitoring RSVP-TE Hello Adjacency Instances on page 363
■ Monitoring Status and Configuration for MPLS Tunnels on page 365
■ Verifying and Troubleshooting MPLS Connectivity on page 367
■ Packet Flow Examples for Verifying MPLS Connectivity on page 369
■ Troubleshooting MTU Problems in Point-to-Point LSPs on page 376
Setting the Baseline for MPLS Statistics
You can use the baseline mpls commands to set a statistics baseline for MPLS
operations. The router implements the baseline by setting the statistics to zero and
then subtracting this baseline when you retrieve baseline-relative statistics.
Use the delta keyword with the show mpls commands to display baselined statistics.
Tasks to set a baseline for MPLS statistics are:
■ Setting a Baseline for MPLS Major Interface Statistics on page 316
■ Enabling and Setting a Baseline for MPLS Forwarding Table Statistics on page 317
■ Enabling and Setting a Baseline for MPLS Next-Hop Table Statistics on page 318
■ Setting a Baseline for MPLS Tunnel Statistics on page 318
■ Enabling Statistics Collection for Policies Attached to MPLS Tunnels on page 318
Setting a Baseline for MPLS Major Interface Statistics
To set a statistics baseline for MPLS major interfaces:
316 ■ Setting the Baseline for MPLS Statistics
JUNOSe 11.1.x BGP and MPLS Configuration Guide