Juniper BGP - CONFIGURATION GUIDE V 11.1.X - Monitoring LDP Neighbors

Table 40: show ldp interface Output Fields (continued)
Field DescriptionField Name
Number of hello messages received badbad hello recv
Time in hh:mm:ss since adjacency set upadj setup time
Time in hh:mm:ss since last hello message receivedlast hello recv time
Time in hh:mm:ss since last hello message sentlast hello sent time
Time in hh:mm:ss remaining of the hold timeremaining hold time
IP address of the interfaceIP-Address
Administrative state of LDP, enabled or disabledProtocol
Related Topics ■ show ldp interface
Monitoring LDP Neighbors
Purpose Display LDP neighbor information.
Action To display information about LDP neighbor 10.3.5.1:
host1#show ldp neighbor 10.3.5.1
LDP Neighbor: 10.0.2.2
LSR: Remote 10.0.2.2:0, local 10.0.1.1:0
Transport address: remote 10.0.2.2, local 10.0.1.1
State: Operational
LDP advertisement: Unsolicited
Up for 00:20:03
Number of next-hop addresses received = 3
10.0.2.2 100.6.12.2 100.6.23.2
Number of adjacencies = 1
Link Hello adjacency: address 10.6.12.2, transport 10.0.2.2,
Up for 00:20:09, remaining hold time: 11 sec
To display brief information about all LDP neighbors:
host1#show ldp neighbor brief
Neighbor Transport Address State
10.0.2.2 10.0.1.1->80.0.2.2 Operational
To display information about graceful restart for neighbors:
host1#show ldp neighbor graceful-restart
LDP Neighbor: 10.0.1.1
Graceful Restart is disabled
Helper Mode is enabled
Reconnect Time: 0 msec
332 ■ Monitoring LDP Neighbors
JUNOSe 11.1.x BGP and MPLS Configuration Guide