Table 72: show mpls forwarding Output Fields
Field DescriptionField Name
Interface specifiername/id
Destination IP addressdestination
Label sent to upstream neighbor for routeIn label
Label received from downstream neighbor for routeOut label
Number of packets sent across tunnelpkts
Number of high-capacity (64-bit) packets sent across tunnelhcPkts
Number of octets sent across tunneloctets
Number of high-capacity (64-bit) octets sent across tunnelhcOctets
Number of packets dropped for some reason before being senterrors
Number of packets discarded due to lack of buffer space before
being sent
discardPkts
Related Topics â– show mpls forwarding
Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS
Purpose Display status and configuration information about MPLS layer 2 major, minor, and
shim interfaces. Both the show mpls interface shim command and the show mpls
l2transport interface command provide the same output. The shim keyword displays
all shim interfaces. The brief keyword displays only limited interface information.
Action To display information about MPLS layer 2 interfaces:
host1#show mpls interface shim
MPLS shim interface FastEthernet2/0
Remote PE address is 10.9.1.3
Virtual circuit ID is 1
Group ID is 0 by default
Control word is not preferred by default
Don't send sequence numbers by default
Relay format is ethernet by default
ATM VPI/VCI range is 1-2/100-109 (up on the line card)
ATM VPI/VCI range is 5-10/200-300 (up on the line card)
ATM cell aggregation is enabled
ATM cell aggregation maximum cells per packet is 20
ATM cell aggregation timeout timerId is 2
Administrative state is enabled
Operational state is down (shim interface does not have a next-hop)
Operational MTU is 1500
568 â– Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
