Juniper BGP - CONFIGURATION GUIDE V 11.1.X User Manual

Received:
0 packets
0 bytes
1 error
0 discards
Sent:
0 packets
0 bytes
0 errors
0 discards
received mtu 0
queue 0: traffic class best-effort, bound to ethernet FastEthernet2/0
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
MPLS policy input shimRl
classifier-group *
0 packets, 0 bytes
rate-limit-profile shimRl
committed: 0 packets, 0 bytes
conformed: 0 packets, 0 bytes
exceeded: 0 packets, 0 bytes
MPLS policy output shimRl
classifier-group *
0 packets, 0 bytes
rate-limit-profile shimRl
committed: 0 packets, 0 bytes
conformed: 0 packets, 0 bytes
exceeded: 0 packets, 0 bytes
This excerpt from the command output shows the label information displayed when
a circuit is up
host1#show mpls l2transport interface
...
Out Label 49 on tun mpls:lsp-de090100-24-37
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
queue 0: traffic class best-effort, bound to atm-vc ATM1/0.1
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
...
To display summary information about MPLS shim interfaces:
host1#show mpls interface shim brief
Remote-PE Virtual Load
or Circuit Balancing Admin Oper
Interface LSP-name ID Group state state
----------------- --------- ------- --------- ------- -----
FastEthernet2/0.1 222.9.1.3 200001 - enabled up
FastEthernet2/0.2 222.9.1.3 200002 - enabled up
Meaning Table 73 on page 570 lists the show mpls interface and show mpls l2transport
interface command output fields
Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS ■ 569
Chapter 8: Monitoring Layer 2 Services over MPLS

Juniper BGP - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	BGP - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English