Table 94: Commands for Monitoring VPLS BGP Settings
show ip bgp neighbors pathsshow ip bgp
show ip bgp neighbors received-routesshow ip bgp advertised-routes
show ip bgp neighbors routesshow ip bgp community
show ip bgp networkshow ip bgp community-list
show ip bgp next-hopsshow ip bgp dampened-paths
show ip bgp pathsshow ip bgp filter-list
show ip bgp peer-groupshow ip bgp flap-statistics
show ip bgp quote-regexpshow ip bgp l2vpn
show ip bgp regexpshow ip bgp l2vpn vpls
show ip bgp summaryshow ip bgp neighbors
–show ip bgp neighbors dampened-routes
Related Topics Monitoring Layer 2 NLRI for VPLS Instances on page 632â–
â– Monitoring BGP Next Hops for VPLS on page 635
â– For more information about using these commands, see Configuring BGP Routing
on page 3 and Configuring BGP-MPLS Applications on page 379.
Monitoring Layer 2 NLRI for VPLS Instances
Purpose Display layer 2 NLRI for all VPLS instances in the L2VPN address family, for a
particular VPLS instance in the L2VPN address family, or for a particular VPLS instance
in the VPLS address family.
The l2vpn vpls keywords display layer 2 NLRI for a particular VPLS instance in the
VPLS address family.
The l2vpn all keywords display layer 2 NLRI for all VPLS instances in the L2VPN
address family. The output for this version of the command also includes information
about any VPWS instances configured in the L2VPN address family.
To display layer 2 NLRI for the route that matches a specified prefix (site ID and
block offset) in the L2VPN address family or in the VPLS address family, use the
site-id and block-offset keywords.
Action To display information for all VPLS instances (and all VPWS instances) in the L2VPN
address family:
host1#show ip bgp l2vpn all
Local BGP identifier 1.1.1.1, local AS 100
632 â– Monitoring Layer 2 NLRI for VPLS Instances
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
