Table 53: show mpls profile Output Fields
Field DescriptionField Name
Number of interfaces that use the profileprofile
Timeout period in seconds between generation of refresh messagesrefresh-period
Number of refresh messages that can be lost before the session is
ended
timeout factor
Related Topics ■ show mpls profile
Monitoring RSVP Path State Control Blocks, Reservation State Control Blocks, or
Sessions
Purpose Display RSVP path state control blocks, reservation state control blocks, or session
information about the virtual router to assist in debugging. A session can be any of
the following:
■ ingress session—Originating on the router
■ egress session—Terminating on the router
■ transit session—Travelling through the router
Action To display path state control blocks for an ingress session:
host1#show mpls rsvp psb
PSB: Sender 223.10.1.1 LSPId 1 timeout -- InLabel --
PHopIntf
IncomingIntf
OutgoingIntf ATM2/0.1
PHopAddr 0.0.0.0 m_ipNextHopAddr 221.1.1.1
NextHop 221.1.1.1/255.255.255.255 (strict)
LabelRange --
SenderTSpec CType IntServ Controlled Load
Token Bucket Rate 0
Token Bucket Size 0
Peak Data Rate 0
Min Policed Unit 0
Max Packet Size 0
Flags : InUse
RroRequired
PathRefreshSent
To display reservation state control blocks for an ingress session:
host1#show mpls rsvp rsb
RSB: Timeout 157500 label 1/33
Flags : InUse
StyleConverted
354 ■ Monitoring RSVP Path State Control Blocks, Reservation State Control Blocks, or Sessions
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...