■ Encapsulation Methods for Transport of PPP/HDLC Over IP and MPLS
Networks—draft-ietf-pwe3-hdlc-ppp-encap-mpls-03.txt (October 2004 expiration)
■ Framework for Pseudo Wire Emulation Edge-to-Edge
(PWE3)—draft-ietf-pwe3-arch-06.txt (April 2004 expiration)
■ IEEE 802.3ad (Link Aggregation)
■ Pseudowire Setup and Maintenance Using
LDP—draft-ietf-pwe3-control-protocol-08.txt (January 2005 expiration)
■ Requirements for Pseudo-Wire Emulation Edge-to-Edge
(PWE3)—draft-ietf-pwe3-requirements-08.txt (June 2004 expiration)
■ Transport of Layer 2 Frames Over MPLS—draft-martini-12circuit-trans-mpls-11.txt
(October 2003 expiration)
NOTE: IETF drafts are valid for only 6 months from the date of issuance. They must
be considered as works in progress. Please refer to the IETF Web site at
http://www.ietf.org for the latest drafts.
For information about configuring supported layer 2 interfaces, consult the following
resources:
■ JUNOSe Physical Layer Configuration Guide
■ See Configuring ATM in JUNOSe Link Layer Configuration Guide.
■ See Configuring Frame Relay in JUNOSe Link Layer Configuration Guide.
■ See Configuring Packet over SONET in JUNOSe Link Layer Configuration Guide.
■ See Configuring Bridged Ethernet in JUNOSe Link Layer Configuration Guide.
For information about configuring supported serial interfaces, which are also referred
to as HDLC channels, see the following resources:
■ See Configuring Channelized T3 Interfaces in JUNOSe Physical Layer Configuration
Guide.
■ See Configuring T3 and E3 in JUNOSe Physical Layer Configuration Guide.
■ See Configuring Channelized OCx/STMx Interfaces in JUNOSe Physical Layer
Configuration Guide.
For information about configuring MPLS, see “Configuring MPLS” on page 267.
Layer 2 Services over MPLS Implementation
When layer 2 services are configured over MPLS, layer 2 traffic is encapsulated in
MPLS frames and sent over MPLS tunnels. A virtual circuit (VC) label that indicates
a specific layer 2 connection, such as a Frame Relay data-link connection identifier
(DLCI), is pushed into the label stack between the tunnel label and the layer 2 data.
512 ■ Layer 2 Services over MPLS Implementation
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...