Topology changes 5
No router id 0
No address 0
No interface 0
No session 0
No adjacency 0
Unknown version 0
Malformed PDU 0
Malformed message 0
Unknown message type 0
Inappropriate message 0
Malformed tlv 0
Bad TLV value 0
Missing TLV 0
PDU too large 0
PDU too small 0
No Memory 0
NOTE: The mpls keyword is optional and is provided for compatibility with non–E
Series implementations.
Meaning Table 43 on page 336 lists the show ldp statistics command output fields.
Table 43: show ldp statistics Output Fields
Field DescriptionField Name
Number of hello messages received and sentHello
Number of initialization messages received and sentInitialization
Number of keepalive messages received and sentKeepalive
Number of notification messages received and sentNotification
Number of address messages received and sentAddress
Number of address withdraw messages received and sentAddress withdraw
Number of label mapping messages received and sentLabel mapping
Number of label request messages received and sentLabel request
Number of label withdraw messages received and sentLabel withdraw
Number of label release messages received and sentLabel release
Number of label abort messages received and sentLabel abort
Number of UDP messages received and sentAll UDP
Number of TCP messages received and sentAll TCP
Number of session opened eventsSessions opened
336 â– Monitoring LDP Statistics
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Need help?
General
