â– Issue the clear ip bgp wait-end-of-rib command and include the l2vpn all
keywords.
host1#clear ip bgp l2vpn all wait-end-of-rib
There is no no version.
Related Topics â– Configuring BGP Routing on page 3
â– clear ip bgp
â– clear ip bgp dampening
â– clear ip bgp wait-end-of-rib
Monitoring BGP-Related Settings for VPWS L2VPNs
This section provides examples of some of the show ip bgp commands that you can
use to monitor VPWS configurations.
You can use the show ip bgp commands listed in Table 103 on page 673 to display
BGP-related settings for VPWS instances in the L2VPN address family. The l2vpn all
keywords display both all VPWS instances and all VPLS instances in the L2VPN
address family
Table 103: Commands for Monitoring BGP Settings for the VPWS Address Family
show ip bgp neighbors received-routesshow ip bgp advertised-routes
show ip bgp neighbors routesshow ip bgp l2vpn all
show ip bgp peer-groupshow ip bgp neighbors
show ip bgp neighbors dampened-routes
You can use the show ip bgp commands listed in Table 104 on page 673 to display
BGP-related settings for L2VPNs. Specify l2vpn vpws vpwsName to display information
about only the VPWS instances in the VPWS address family. Specify l2vpn all to
display information about all VPWS instances in the VPWS address family and all
VPLS instances in the VPLS address family.
Table 104: Commands for Monitoring BGP Settings for the VPWS Address Family
show ip bgp l2vpn vpwsshow ip bgp
show ip bgp next-hopsshow ip bgp community
show ip bgp pathsshow ip bgp community-list
show ip bgp quote-regexpshow ip bgp dampened-paths
Monitoring BGP-Related Settings for VPWS L2VPNs â– 673
Chapter 14: Monitoring VPWS
To Next Page
Need help?
General
