Targeted session sent to 10.9.1.3 is up Used By: D
indirect nexthop index 3, resolved
Targeted session sent to 10.9.1.6 is up Used By: S
indirect nexthop index 206, resolved
Meaning Table 44 on page 338 lists the show ldp targeted session command output fields.
Table 44: show ldp targeted session Output Fields
Field DescriptionField Name
Targeted session created by layer 2 over MPLS connection; see
Layer 2 Services over MPLS Overview in the JUNOSe BGP and MPLS
Configuration Guide for more information about layer 2 over MPLS
D
Targeted session statically created by userS
Targeted session created by access listA
Letter representing source of targeted sessionUsed By
Related Topics â– show ldp targeted session
Monitoring MPLS Status and Configuration
Purpose Display status and configuration information about MPLS.
Action To display information about MPLS Status and configuration:
host1#show mpls
MPLS administratively enabled
Current state is Config incomplete
LSR ID is 10.2.2.2
Re-optimization timer is 3600
Label range 3000 ~ 4000
retry forever at interval 30 during LSP setup if there is route
retry forever at interval 30 during LSP setup if there is no route
Loop Detect enabled
Additional detail is shown when LDP is enabled:
LDP
LSR ID is 80.0.0.2
FEC Deaggregation is off
Egress label: implicit-null
Label distribution control mode: ordered control
LDP session retry 0 times at interval 10
LDP session hold time: 180
LDP session keepalive interval: 20
LDP targeted-hello hold time: 45
LDP targeted-hello interval: 15
338 â– Monitoring MPLS Status and Configuration
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
