Chapter 11
Monitoring VPLS
This chapter describes the commands you can use to monitor and troubleshoot the
virtual private LAN service (VPLS) on E Series routers.
NOTE: The E120 and E320 Broadband Services Routers output for monitor and
show commands is identical to output from other E Series routers, except that the
E120 and E320 router output also includes information about the adapter identifier
in the interface specifier (slot/adapter/port).
This chapter contains the following sections:
■ Setting a Baseline for VPLS Statistics on page 614
■ Clearing Dynamic MAC Addresses from the VPLS Forwarding Table on page 615
■ Clearing BGP Attributes for VPLS on page 616
■ Monitoring Bridging-Related Settings for VPLS on page 617
■ Monitoring VPLS Configuration and Statistics for a Specific VPLS
Instance on page 618
■ Monitoring VPLS Configuration and Statistics for all VPLS Instances on page 620
■ Monitoring Configuration, Statistics, and Status for VPLS Network
Interfaces on page 622
■ Monitoring Configuration, Statistics, and Status for VPLS Core
Interfaces on page 625
■ Monitoring Configuration, Statistics, and Status for VPLS Ports on page 627
■ Monitoring MAC Address Entries for a Specific VPLS Instance on page 629
■ Monitoring Subscriber Policy Rules on page 630
■ Monitoring BGP-Related Settings for VPLS on page 631
■ Monitoring Layer 2 NLRI for VPLS Instances on page 632
■ Monitoring BGP Next Hops for VPLS on page 635
■ Monitoring LDP-Related Settings for VPLS on page 636
■ Monitoring MPLS-Related Settings for VPLS on page 637
■ Monitoring VPLS-Specific Settings on page 638
■ 613
To Next Page
Loading...