Juniper BGP - CONFIGURATION GUIDE V 11.1.X

Setting a Baseline for VPLS Statistics
You can use the following baseline commands to set a statistics baseline for a VPLS
instance, for a network interface associated with a VPLS instance, or for the VPLS
virtual core interface associated with a VPLS instance. The router implements the
baseline by reading and storing the statistics at the time the baseline is set and then
subtracting this baseline whenever baseline-relative statistics are retrieved.
Use the delta keyword with the show bridge commands display baselined statistics.
Tasks to set a baseline for VPLS statistics are:
■ “Setting a Baseline for a VPLS Instance” on page 614
■ “Setting a Baseline for a Network Interface Associated with a VPLS Instance”
on page 614
■ “Setting a Baseline for the VPLS Virtual Core Interface Associated with a VPLS
Instance” on page 614
Setting a Baseline for a VPLS Instance
To set a statistics baseline for a VPLS instance:
■ Issue the baseline bridge command.
host1#baseline bridge vplsA
There is no no version.
Setting a Baseline for a Network Interface Associated with a VPLS Instance
To set a statistics baseline for the VPLS network interface:
■ Issue the baseline bridge interface command.
host1#baseline bridge interface gigabitEthernet 4/1
Setting a Baseline for the VPLS Virtual Core Interface Associated with a VPLS Instance
To set a statistics baseline for the VPLS virtual core interface:
■ Issue the baseline bridge interface vpls command.
host1#baseline bridge interface vpls vplsA
There is no no version.
Related Topics baseline bridge■
614 ■ Setting a Baseline for VPLS Statistics
JUNOSe 11.1.x BGP and MPLS Configuration Guide