Juniper BGP - CONFIGURATION GUIDE V 11.1.X User Manual

■ Use to set the baseline on all BGP statistics as the current values.
■ For example, if you issue the baseline ip bgp command, all the current values
of BGP statistics become the baseline values. If the current value of the Total
message sent parameter is 105, and the value goes up to 120 messages, the new
value is displayed as 15.
■ Example
host1#baseline ip bgp
■ There is no no version.
■ See baseline ip bgp.
debug ip bgp
■ Use to display information about BGP logs for inbound or outbound events, or
both.
■ Example
host1#debug ip bgp
■ There is no no version, but you can use the undebug ip bgp command to disable
display of information previously enabled with the debug ip bgp command.
■ See debug ip bgp.
default-fields peer
■ Use to specify fields that are displayed by default by a subsequently issued show
ip bgp summary command.
■ Use the intro keyword to enable the display of introductory information about
BGP attributes.
■ The order in which you specify the fields has no effect on the order in which
they are displayed.
■ Example
host1:pe2(config-router)#default-fields peer remote-as state
messages-received messages-sent up-down-time
host1:pe2#show ip bgp summary
Messages Messages
Neighbor AS State Up/down time Sent Received
1.1.1.1 100 Established 00:07:55 94 92
■ Use the no version to remove fields from the output of subsequently issued show
ip bgp summary commands.
■ See default-fields peer.
default-fields route
Monitoring BGP ■ 159
Chapter 1: Configuring BGP Routing

Juniper BGP - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	BGP - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English