Juniper BGP - CONFIGURATION GUIDE V 11.1.X

List of Tables
About the Documentation xxxiii
Table 1: Notice Icons ................................................................................xxxiv
Table 2: Text and Syntax Conventions ......................................................xxxiv
Part 1 Border Gateway Protocol
Chapter 1 Configuring BGP Routing 3
Table 3: Conventions for BGP Terms ...............................................................4
Table 4: Cease Notification Message Subcodes ................................................8
Table 5: Commands Affecting BGP Globally ..................................................18
Table 6: Commands Affecting All Address Families in a VRF .........................18
Table 7: Commands Affecting the Current Address Family ...........................19
Table 8: Commands Affecting All Address Families for the Specified Peer or
Peer Group ..............................................................................................19
Table 9: Commands Affecting Only the Current Address Family for the
Specified Peer or Peer Group ..................................................................20
Table 10: Behavior of Neighbor Commands ..................................................21
Table 11: Inheritance from Other Commands ...............................................22
Table 12: Commands That Do Not Override Inherited Outbound Policy .......24
Table 13: Source Addresses and Default Next Hop Addresses for Various
Configurations ........................................................................................31
Table 14: Commands That Create Match-and-Set Route Maps .......................71
Table 15: Clauses Supported in BGP Match-and-Set Route Maps ...................71
Table 16: Commands That Create Match-Only Route Maps ...........................72
Table 17: Clauses Not Supported in BGP Route Maps ....................................72
Table 18: Set Clauses Supported in Route Maps Applied with the Table-Map
Command ...............................................................................................81
Table 19: Action Based on Well-Known Community Membership .................92
Table 20: Origin and AS Path for Routes Viewed on Different Routers ........119
Table 21: Default Administrative Distances for Route Sources .....................136
Part 2 Multiprotocol Layer Switching
Chapter 2 MPLS Overview 201
Table 22: Conventions for MPLS Terms .......................................................202
Table 23: MPLS Terms and Acronyms .........................................................204
Table 24: TLVs Supported by MPLS LSP ping ..............................................234
Table 25: Sub-TLVs Supported for the Target FEC Stack TLV .......................235
Table 26: Sub-TLVs Supported for the P2MP Responder Identifier TLV .......240
Table 27: Summary of LDP Graceful Restart States .....................................248
Chapter 3 Configuring MPLS 267
List of Tables ■ xxix