Juniper BGP - CONFIGURATION GUIDE V 11.1.X User Manual

When you configure a node as the downstream endpoint of an LSP, you must provide
a stable interface as the router ID for the endpoint. Typically you select a loopback
interface because of its inherent stability. Use the mpls traffic-eng router-id
command to designate the router as traffic engineering capable and to specify the
router ID. For all tunnels that end at this node, set the tunnel destination to the
destination node's traffic-engineering router identifier, because the traffic-engineering
topology database at the tunnel ingress uses that for its path calculation.
You can use the show isis mpls and show isis database commands to display
information about IS-IS traffic engineering:
For OSPF, you can use the show ip ospf database opaque-area command to display
information about traffic-engineering opaque LSAs.
Related Topics ■ See JUNOSe IP, IPv6, and IGP Configuration Guide for more information about
enabling IS-IS to support traffic engineering and monitoring IS-IS traffic
engineering
■ See JUNOSe IP, IPv6, and IGP Configuration Guide for more information about
enabling OSPF to support traffic engineering and monitoring OSPF traffic
engineering
■ For information about BGP and MPLS, see Configuring BGP-MPLS Applications
on page 379
■ metric-style narrow
■ metric-style transition
■ metric-style wide
■ mpls spf-use-any-best-path
■ mpls traffic-eng
■ mpls traffic-eng area
■ mpls traffic-eng router-id
■ show ip ospf database
■ show isis database
■ show isis mpls adjacency-log
■ show isis mpls advertisements
■ show isis mpls tunnel
■ tunnel mpls autoroute announce
■ tunnel mpls autoroute metric
298 ■ Configuring IGPs and MPLS
JUNOSe 11.1.x BGP and MPLS Configuration Guide

Juniper BGP - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	BGP - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English