Administrative state is enabled
Operational state is up
Operational MTU is 9180
Received:
0 packets
0 bytes
0 errors
0 discards
0 failed label lookups
Sent:
0 packets
0 bytes
0 errors
0 discards
LDP information:
10.1.1.2/24
enabled with profile 'default'
0 hello recv, 1 hello sent, 0 hello rej
0 adj setup, 0 adj deleted,
RSVP
Enabled with profile default
Authentication is disabled
Authentication key: <none>
Hellos are on with an interval of 10000 and miss limit of 4
Hello settings are not inherited
MPLS minor interface pe1-to-pe2 (transmit)
Stacked on MPLS major ATM2/0.10
Operational state is up
Sent:
0 packets
0 bytes
queue 0: traffic class best-effort, bound to atm-vc ATM2/0.10
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
MPLS minor interface lsp-02020202-1-4 (receive)
Stacked on MPLS major ATM2/0.10
Operational state is up
Statistics not enabled for this interface
■ The following excerpt shows the output for MPLS interface atm 5/1.1 when
RSVP-TE is enabled and RSVP-TE authentication is enabled:
host1:pe2#show mpls interface atm 5/1.1
Interface ATM5/1.1 Up
RSVP enabled with profile default
Authentication: enabled
Authentication Key: <a password has been configured>
LDP not configured
IP interfaces on this MPLS interface:
192.168.100.21/30
MPLS Statistics:
Rcvd: 0 failed lbl lookup, 0 octets, 0 hcOctets
0 pkts, 0 hcPkts, 0 errors, 0 discards
Sent: 0 octets, 0 hcOctets, 0 pkts
0 hcPkts, 0 errors, 0 discards
...
344 ■ Monitoring MPLS Interfaces
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...