Table 49: show mpls interface Output Fields (continued)
Field DescriptionField Name
Cumulative total number of labels allocated and advertised to this
peer
accum label alloc
Cumulative total number of labels received from this peeraccum label learned
Number of notification messages received or received bad or sentnotf
Number of label mapping messages received or received bad or
sent
mapping
Number of messages sent or receivedmsg
Number of label request messages received or received bad or sentrequest
Number of label request abort messages for downstream on
demand received or received bad or sent
abort
Number of label release messages received or received bad or sentrelease
Number of label withdraw messages received or received bad or
sent
withdraw
Number of address messages received or received bad or sentaddr
Number of address withdraw messages received or received bad
or sent
addr withdraw
Number of message IDs received or sentmsgId
Number or unknown message type errors receivedunknown message type err
Last received notification codelast info error code
Loop detected; for downstream on demandloop detected
Number of hello messages receivedhello recv
Number of hello messages senthello sent
Number of hello messages received badbad hello recv
Time in hh:mm:ss since adjacency set upadj setup time
Time in hh:mm:ss since last hello message receivedlast hello recv time
Time in hh:mm:ss since last hello message sentlast hello sent time
Number of packets received whose labels are not recognizedfailed lbl lookup
Number of octets received or sentoctets
Number of high-capacity (64-bit) octets received or senthcoctets
Number of packets received or sentpkts
348 â– Monitoring MPLS Interfaces
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
