Juniper BGP - CONFIGURATION GUIDE V 11.1.X

host1(config)#ip vrf ospf2
Proceed with new VRF creation? [confirm]
host1(config-vrf)#rd 100:85
host1(config-vrf)#exit
2. Start OSPF on the VRF, either from the parent VR or directly from the VRF.
From the parent VR:
host1(config)#router ospf 5 vrf ospf2
From the VRF:
host1(config)#virtual-router :ospf2
host1:default:ospf2(config)#router ospf 5
The command prompts in the remaining steps reflect using the latter method
for starting OSPF.
3. Configure the OSPF domain ID.
host1:default:ospf2(config-router)#domain-id 45
4. Configure the VPN route tag.
host1:default:ospf2(config-router)#domain-tag 1200
5. Redistribute routes learned from other PE routers back into OSPF.
host1:default:ospf2(config-router)#redistribute bgp
6. Create an address family in BGP.
host1:default(config)#router bgp 100
host1:default(config-router)#address-family ipv4 unicast vrf ospf2
7. Redistribute OSPF routes into BGP.
host1:default(config-router)#redistribute ospf
domain-id
■ Use to set the OSPF domain ID for an OSPF VRF on a PE router; the default value
is zero.
■ Use the same domain ID for all OSPF VRFs in a given OSPF domain.
■ When the value is zero, MP-BGP does not attach an OSPF domain identifier
attribute when it converts an OSPF route to an MP-BGP route to cross the
BGP/MPLS VPN.
■ Example
host1:default:ospf2(config-router)#domain-id 45
■ Use the no version to restore the default value.
■ See domain-id.
486 ■ OSPF and BGP/MPLS VPNs
JUNOSe 11.1.x BGP and MPLS Configuration Guide