EasyManua.ls Logo

Juniper BGP - CONFIGURATION GUIDE V 11.1.X

Juniper BGP - CONFIGURATION GUIDE V 11.1.X
748 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Related Topics Monitoring VPLS Configuration and Statistics for a Specific VPLS Instance on
page 618
Monitoring VPLS Configuration and Statistics for all VPLS Instances on page 620
Monitoring Configuration, Statistics, and Status for VPLS Network Interfaces on
page 622
Monitoring Configuration, Statistics, and Status for VPLS Core Interfaces on
page 625
Monitoring Configuration, Statistics, and Status for VPLS Ports on page 627
Monitoring MAC Address Entries for a Specific VPLS Instance on page 629
Monitoring Subscriber Policy Rules on page 630
For more information about using these commands, see Monitoring Transparent
Bridging in the JUNOSe Link Layer Configuration Guide.
Monitoring VPLS Configuration and Statistics for a Specific VPLS Instance
Purpose Display configuration and statistics information for the specified VPLS instance.
Action To display configuration information for a specified VPLS (vplsA):
host1#show bridge vplsA
BridgeGroup: vplsA(vpls)
Bridge Mode: default
Aging Time: 300 secs
Learning: Enabled
Max Learn: Unlimited
Link Status Snmp Traps: Disabled
Subscriber Policy: default Subscriber
Port Count: 2
Interface Count: 1
Transport Virtual Rtr: default
Route Distinguisher: 1.1.1.1:10
SiteName: boston
SiteId: 1
Multi-homed: Yes
Site-Priority: 45
SiteRange: 10
VPLS Route Targets
Route Target: RT:100:1 (both)
Route Target: RT:100:2 (both)
Flood Next Hop: Index 1048577
Use the all keyword to display address table and statistics information for all network
interfaces associated with the VPLS instance.
Meaning Table 85 on page 619 lists the show bridge command output fields.
618 Monitoring VPLS Configuration and Statistics for a Specific VPLS Instance
JUNOSe 11.1.x BGP and MPLS Configuration Guide

Table of Contents

Related product manuals