Admin Oper
Interface Local-Site-Id Remote-Site-Id state state
---------- ------------- -------------- ------- -----
ATM2/0.122 1 2 enabled up
ATM2/0.123 1 3 enabled up
ATM2/0.124 3 1 enabled up
ATM2/0.121 3 2 enabled up
Connections status code:
UP = Operational
SC = Local and Remote Site Identifier Collision
EM = Encapsulation Mismatch
OR = Out of Range
DN = VC Down because Remote PE Unreachable
LD = Local Site Down
RD = Remote Site Down
AS = Max BGP AS path length exceeded
OL = No Out Label
CM = Control Word Mismatch
LN = Local Site not Designated
RN = Remote Site not Designated
Local Remote Remote MPLS Up-down
Site Site State PE In-label Out-label NH Idx Time
----- ------ ----- ------- ------------- ------------- -------- --------
1 2 UP 2.2.2.2 35 84 0000001d 01:50:40
1 3 UP implicit-null implicit-null 2d000008 02:24:45
3 1 UP implicit-null implicit-null 2d000007 02:24:45
3 2 UP 2.2.2.2 55 86 0000001d 01:50:40
To display detailed information about connections for a specific VPWS instance:
host1#show l2vpn connections instance l2vpn1 details
L2VPN: l2vpn1
Encapsulation Type ATM AAL5 SDU VCC transport
Use of control word is preferred
Send sequence numbers
Route Distinguisher 100:11
Site Range 10
Sites:
Site Name westford Site Id 1
Multihomed priority 200
Route Targets:
Route Target: RT:100:2 both
Admin Oper
Interface Local-Site-Id Remote-Site-Id state state
---------- ------------- -------------- ------- -----
ATM2/0.100 1 2 enabled up
ATM2/0.12 1 3 enabled up
Connections status code:
UP = Operational
SC = Local and Remote Site Identifier Collision
EM = Encapsulation Mismatch
OR = Out of Range
DN = VC Down because Remote PE Unreachable
LD = Local Site Down
RD = Remote Site Down
AS = Max BGP AS path length exceeded
OL = No Out Label
CM = Control Word Mismatch
680 â– Monitoring VPWS Connections
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
