Juniper BGP - CONFIGURATION GUIDE V 11.1.X - Page 735

IPv6 Node Address P2MP Responder Identifier
in echo requests containing
Multicast LDP FEC Stack sub-TLVs...............241
RSVP P2MP Session sub-TLVs......................241
inclusion in echo requests
specifies address of physical interface or
router ID..................................................240
using in echo requests
that contain RSVP P2MP Session
sub-TLV....................................................241
IPv6 VPNs
carrier-of-carriers................................................475
global export maps.............................................432
inter-AS services.................................................405
intra-AS services.................................................395
K
keepalive messages
BGP.........................................................................7
L
L-LSP..................................................................205, 303
L2VPN address family..........43, 153, 380, 579, 600, 649
l2vpn commands
l2vpn control-word.............................................659
l2vpn encapsulation-type....................................659
l2vpn local-site-id remote-site-id.........................661
l2vpn rd..............................................................659
l2vpn route-target...............................................659
l2vpn sequencing................................................659
l2vpn site-name site-id........................................659
l2vpn site-range..................................................659
L2VPNs (Layer 2 Virtual Private Networks)
address families, configure.................................410
clear
BGP route flap dampening...........................616
configuration tasks..............................................658
configure
address families...........................................410
L2VPN address family...................................43, 380
VPWS address family............................43, 153, 380
labels, switching of MPLS...........................................210
layer 2 services over MPLS
802.3ad switch...................................................540
AAL0 encapsulation............................................517
AAL5 encapsulation............................................516
ATM passthrough........................................512, 515
AAL5 encapsulation.....................................516
control word support...................................517
limitations...................................................517
Martini encapsulation..................................516
OAM cells....................................................516
QoS classification.........................................517
candidate ports...................................................543
CE-side load balancing........................................540
CE-side MPLS L2VPNs over LAG
overview......................................................521
configuration example........................................544
configuring..........................................................529
configuring shim interfaces.........................515, 534
control word.......................................................512
control word support for ATM passthrough.........517
Ethernet aggregation...........................................540
Ethernet raw mode encapsulation
overview......................................................522
Ethernet/VLAN connections................................533
Frame Relay example.........................................544
HDLC
configuring..................................................538
overview......................................................519
how they work....................................................512
interfaces supported...........................................509
load-balancing
adding member interface to group..............543
configuring..................................................543
group...........................................................540
monitoring...................................................501
topology..............................................540, 542
local cross-connects....................513, 520, 533, 538
monitoring..........................................................563
MPLS L2VPN over LAG, configuration
example..........................................................551
MPLS L2VPN over VLAN over LAG, configuration
example..........................................................547
multiservice traffic, interface stacking for...........515
overview.............................................................509
platform considerations......................................510
ports, candidate..................................................543
references for.....................................................511
S-VLAN subinterface with an untagged C-VLAN ID
overview......................................................524
VCC cell relay encapsulation, ATM
configuring..................................................536
overview......................................................517
LDP (Label Discovery Protocol)
ATM n-to-one VCC cell transport (0x0009)
pseudowire (PW) type
used for multiple VCs transmission..............527
bringing up on the pseudowire
for mismatching VCI/VPI range configurations
at the two pseudowire ends.....................525
LDP (Label Distribution Protocol)...............................229
authentication, MD5...........................................285
autoconfiguration................................................283
basic discovery...................................................242
configuring for VPLS signaling............................607
discovery mechanisms........................................242
extended discovery.............................................242
FEC aggregation..................................................281
FEC deaggregation..............................................281
Index ■ 699
Index