3 Programming the Analyzer
STATus Subsystem
Mode All
Remote Command
:STATus:QUEStionable:CALibration:ENABle <integer>
:STATus:QUEStionable:CALibration:ENABle?
Example STAT:QUES:CAL:ENAB 16384 Can be used to query if an alignment is needed, if you have turned off
the automatic alignment process.
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Event Query
This query returns the decimal value of the sum of the bits in the Questionable Calibration Event register.
The register requires that the associated PTR or NTR filters be set before a condition register bit can set a
bit in the event register. The data in this register is latched until it is queried. Once queried, the register is
cleared.
Mode All
Remote Command
:STATus:QUEStionable:CALibration[:EVENt]?
Example STAT:QUES:CAL?
Preset 0
Status Bits/OPC
dependencies
Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Negative Transition
This command determines which bits in the Questionable Calibration Condition register will set the
corresponding bit in the Questionable Calibration Event register when the condition register bit has a
negative transition (1 to 0). The variable <integer> is the sum of the decimal values of the bits that you want
to enable.
Mode All
Remote Command
:STATus:QUEStionable:CALibration:NTRansition <integer>
:STATus:QUEStionable:CALibration:NTRansition?
Example STAT:QUES:CAL:NTR 16384 Alignment is not required.
Preset 0
Min 0
EMI Receiver Mode Reference 117