6 System Functions
System
Mode All
Remote Command
:CALibration:RFPSelector:SCHeduler:RECurrence:WEEK <integer>
:CALibration:RFPSelector:SCHeduler:RECurrence:WEEK?
Example :CAL:RFPS:SCH:REC:WEEK 2
Notes New scheduled date to run the alignment task will get updated when this parameter is changed. For
model N9038A only.
Preset This is unaffected by Preset but is set to 1 on a “Restore System Defaults->Align”.
State Saved No
Range 1–52
Min 1
Max 52
Initial S/W Revision A.08.00
Day
Enables you to set the Day of the Week the scheduler will run a scheduled task.
Key Path
System, Alignments, RF Preselector, Schedule Setup, Recurrence, Every N Weeks
Mode All
Remote Command
:CALibration:RFPSelector:SCHeduler:RECurrence:DAY SUN | MON | TUE | WED
| THU | FRI | SAT
:CALibration:RFPSelector:SCHeduler:RECurrence:DAY?
Example :CAL:RFPS:SCH:REC:DAY SUN
Notes For model N9038A only.
Preset This is unaffected by Preset but is set to SUN on a “Restore System Defaults->Align”.
State Saved No
Range Sunday|Monday|Tuesday|Wednesday|Thursday|Friday|Saturday
Initial S/W Revision A.08.00
Scheduler
Setting the Scheduler to ON will trigger the execution of the scheduled task based on the recurrence and
time set in the scheduler since the last successful of the specific alignment. A warning condition of “RF
Preselector alignment scheduler is ON” will be appeared when the scheduler is set to ON. OFF will turn off
the Scheduler from running any scheduled task.
Key Path
System, Alignments, RF Preselector
Mode All
Remote Command
:CALibration:RFPSelector:SCHeduler:STATe ON|OFF|0|1
:CALibration:RFPSelector:SCHeduler:STATe?
EMI Receiver Mode Reference 331
To Next Page
Loading...
Need help?
General
