Keysight EXA N9010A - Marker y Axis Value ( Remote Command Only )

9 Strip Chart Measurement
Marker
Key Path
Marker, Select Marker
Remote Command
:CALCulate:SCHart:MARKer[1]|2|...12:X <real>
:CALCulate:SCHart:MARKer[1]|2|...12:X?
Example CALC:SCH:MARK3:X 0
CALC:SCH:MARK3:X?
Notes If no suffix is sent, it will use the fundamental units for the current marker X Axis Scale. If a suffix is
sent that does not match the current marker X Axis Scale unit, an “Invalid suffix” error will be
generated.
The query returns the marker’s absolute X Axis value if the control mode is Normal, or the offset from
the marker’s reference marker, if the control mode is Delta. The query is returned in the
fundamental units for the current marker X Axis scale: seconds. If the marker is off the response is
not a number (NAN).
Preset 0
State Saved No
Min –9.9E+37
Max 9.9E+37
Initial S/W Revision A.07.00
Marker Y Axis Value ( Remote Command Only )
Returns the marker Y Axis value in the current marker Y Axis unit.
Remote Command
:CALCulate:SCHart:MARKer[1]|2|...12:Y?
Example CALC:SCH:MARK11:Y 0
CALC:SCH:MARK11:Y?
Notes The query returns the marker Y-axis result. If the marker is Off the response is not a number (NAN).
State Saved No
Initial S/W Revision A.07.00
Properties
Accesses a menu that allows you to set marker properties and to access the marker trace menu.
Key Path
Marker
Initial S/W Revision A.07.00
636 EMI Receiver Mode Reference