8 Frequency Scan Measurement
Meas Setup
Dependencies Yes
Couplings When the signal list is cleared, this value will reset to 0.
Preset If the signal list is empty, =0
If the signal list is not empty, = number of peaks in signal list table
State Saved Saved in instrument state.
Min 0
Max Number of peaks in the signal list table.
Initial S/W Revision A.07.00
Navigate
This menu enables you to navigate through the signal list without using a mouse.
Key Path
Meas Setup, Signal List
Initial S/W Revision A.07.00
Page Up
If the signal list fills more than one page, pressing this key moves the signal list up by one page.
Key Path
Meas Setup, Signal List, Navigate
Notes Front panel only.
Dependencies This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a “–221, Settings conflict” warning.
Initial S/W Revision A.07.00
Page Down
If the signal list fills more than one page, pressing this key moves the signal list down by one page.
Key Path
Meas Setup, Signal List, Navigate
Notes Front panel only.
Dependencies This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a “–221, Settings conflict” warning.
Initial S/W Revision A.07.00
440 EMI Receiver Mode Reference
To Next Page
Loading...
Need help?
General
