KDC User Manual BLUETOOTH
104
3.8 Buffer(Memory) Full
The KDC will display the message
Buffer Full
when there is no more space in the flash memory
or the number of collected barcodes reaches the maximum number of stored barcode. To
prevent the loss of data, you should synchronize the data then reset the memory when this
message is displayed.
The 4MB/8MB version KDC reaches the Buffer Full condition in the following situations:
• 0.5MB Partition - Collected data size reaches 0.5MB or collected number is 25,600
• 1MB Partition - Collected data size reaches 1MB or collected number is 51,200
• 2MB Partition - Collected data size reaches 2MB or collected number is 102,400
• 3MB Partition - Collected data size reaches 3MB or collected number is 153,600
• 4MB Partition - Collected data size reaches 4MB or collected number is 204,800
• 5MB Partition - Collected data size reaches 5MB or collected number is 256,000
• 6MB Partition - Collected data size reaches 6MB or collected number is 307,200
• 7MB Partition - Collected data size reaches 7MB or collected number is 358,400
• 8MB Partition - Collected data size reaches 8MB or collected number is 409,600
To Next Page
Loading...
