KDC User Manual BLUETOOTH
90
KDC provides Handshake mode when Data Format is set to Packet Data.
⚫ Handshake Mode will increase the reliability of barcode data transmission.
⚫ The default mode for Handshake is disabled.
⚫ Data transmission speed is slower when Handshake Mode is enabled.
Terminator
The KDC supports various termination characters when the Data Format mode is set to Barcode
only. Select <NONE>, <CR>, <LF>, <CR+LF>, or <TAB> as the termination character. The
default terminator is <CR+LF>. The Up/Down/Left/Right arrow terminator is also available for
HID mode.
Chk Duplicate
This option prevents you from collecting duplicate data.
Enter Key
(KDC350/500 only)
This option determines the behavior of the ‘#’ key on the keypad.
⚫ If this option is enabled, the ‘#’ key acts as a keyboard enter key.
➢ The ‘#’ key finishes the current data input, and stores/sends input data according
to the menu settings of Wedge/Store.
➢ The cursor moves to next line after the current data input is complete, regardless
of whether there is a data input or not.
➢ The screen is scrolled up one line if the ‘#’ key is pressed on the last line of KDC
screen.
➢ If ‘Shift’ is enabled, remember that the ‘#’ key will input the ‘#’ character.
Extend Key
(KDC350/500 only)
This option enables users to enter more symbols by using keypad.
Age Verification
(KDC30/270C/280C/300/350C/420/421/425/450/470C)
This option enables to verify age by reading driver license.
BT Config Menu – KDC20/30/200/250/270/300/350/400/470/500
The KDC supports
Bluetooth
Ver2.1+EDR. Before utilizing the advantages of Bluetooth
functionality with the KDC, the user should become familiar with Bluetooth connectivity and its
impact on the host environment.
To configure your KDC for Bluetooth functionality, you may use the KDC Menus.
Below is a listing of the Bluetooth options and their settings. The default settings for these
options have been set to increase the usability of Bluetooth technology without compromising
the KDC battery usage.
To Next Page
Loading...
