KDC User Manual SYNCHRONIZATION
141
[Note]
• Set the KDC date to current date when using provided certificates.
• Rename InsertData.php.GET when using HTTP GET method.
• Rename InsertData.php.POST when using HTTP POST method.
WiFi Roaming
KDC does support roaming between APs which has the same SSID. When user presses Scan
button, KDC checks current APs signal strength. If the signal strength is lower than pre-defined
threshold, KDC disconnects from current connected AP and connect to new AP which has
strongest signal strength. Usually it takes about 3-4 seconds. KDC provides a way to set the
signal strength(RSSI) threshold and user can set it from -30 to -90.
The overall work flow is as following.
To Next Page
Loading...
