KoamTac KDC20 - ICCR Config Menu - KDC500

KDC User Manual BLUETOOTH
97
⚫ Specify the AES key length.
⚫ Options: 128bits/192bits/256bits
Card Type
The user may select which type of MS card to read.
⚫ ISO
⚫ OTHER 1
⚫ AAMVA
⚫ JIS(KDC500 only)
Track Separator(KDC415/425/430 only)
⚫ Specify the separator which will be added between track data
⚫ Options: None, Space, Comma, Semicolon, CR, LF, CR&LF, Tab
Attach SS/ES
When this option is enabled, KDC does not exclude the Start Sentinal(SS) and End Sentinal(ES)
control characters in the track data when it sends the card data to the connected Host device.
Partial Data(KDC415/425/430 only)
Enables the user to transfer partial MSR data. The user defines the start position and number of
characters to be transferred.
⚫ Start position
◆ This option specifies the start position of data.
⚫ No of char(s)
◆ This option specifies the length of data. The ‘0’ means all data.
⚫ Action
◆ This option selects if erasing or taking the specified data.
ICCR Config Menu – KDC500
Power
⚫ Turning ICCR(IC Card Reader) on or off
⚫ Options: Enable/Disable
IFD Number
This option shows the EMV IFD(Interface Device) number.