KDC User Manual BLUETOOTH
85
This option enables the user to capture an image in JPEG format in C:\myData folder. You
should enable the image capture option first, and then press the Scan button to start the aiming.
A green aiming light will illuminate and an image will be taken upon release of the Scan button.
KDC will disable the image capture option if the user presses the scan button for 5 seconds.
Security Level
(Laser Model only)
This menu enables the user to ensure an accurate barcode reading by setting the number of
times the KDC will read a barcode. Security Level is set from 1 up to 4. The higher security level
means readings are more reliable; however, some performance degradation is likely. For poor
quality barcodes, we recommend increasing the security level. The default is 2.
Auto Trigger
Once enabled, Auto Trigger enables the user to scan a barcode automatically. You may adjust
reread delay from continuous to extra-long. Auto Trigger mode always enables the duplicate
check option.(1D Model only)
•
USB cable insertion requirement is removed from FW2.85/86.O and FW 3.02.
•
You may exit the auto trigger mode by pressing the scan button for 3 seconds.
Reread Delay
You may adjust the reread delay from continuous to extra-long.
Partial Display
This option enables the user to display partial data. You may define the start position and
number of characters to be displayed.
Data Process Menu
Wedge/Store
The KDC provides five modes of data transmission in keyboard wedging mode.
⚫ Wedge Only: Barcode data is NOT stored in memory but transmitted to the host.
⚫ Wedge & Store Only: Barcode data is stored in memory and transmitted to the host.
⚫ Store Only: Barcode data is stored in memory but NOT transmitted to the host.
⚫ Save if Sent: If data transmission is successful, barcode data is stored in memory.
⚫ Save if Not Sent: If data transmission is NOT successful, barcode data is stored in
memory.
Data Format
To Next Page
Loading...
