KDC User Manual BLUETOOTH
119
For KDC500 paring with the host, Numeric Comparions pairing method is required for PCI PTS
complicance. See the section 2.1 Bluetooth Paring for the details.
Discovering
KDC200/250/270/300/350 starts to search for neighboring
Bluetooth
devices if the Discovering
menu is executed. It will take about 30 seconds to finish searching and to list available
neighboring
Bluetooth
devices. Another option is to enter the corresponding Bluetooth MAC
address in the KTSync Bluetooth menu, instead of waiting for the KDC to search for
neighborhood
Bluetooth
devices. KDC20/30/400/470 only supports via KTSync configuration.
KDC500 doesn’t support this feature.
Connect To
This option lets you easily connect the KDC to
Bluetooth
devices that have been either
previously registered in KTSync under the File Menu or discovered/connected from the KDC
Bluetooth
Service menu. KDC20/30/400/470 only supports via KTSync configuration. KDC500
doesn’t support this feature.
There could be an interoperability issue depending on the corresponding device
Bluetooth stack. The master Bluetooth device may request that you to follow the
master Bluetooth device’s security procedures, if the KDC tries to connect to the
master Bluetooth device.
HID Sync
The user may synchronize stored barcode data over HID using the HID Sync option. The KDC will
start to transmit all stored barcode data upon execution of the HID Sync option. KDC500 doesn’t
support this feature.
Tips
Pair and connect KDC20i/30i/200i/250i/270i/300i/350i/400i/470i and iOS4.0+ in HID iOS mode
• Users have to disable the MFi option in System > MFi menu and change the
Bluetooth profile to HID-iOS to use HID Bluetooth profiles
.
• Users have to RESET the iPhone/iPad/iPod touch in order to change HID to MFi
mode, and vice versa, after removing a previous KDC connection.
• KDC with Bluetooth Spec2.1+EDR does not prompt Pin code entry menu.
• KDC with Bluetooth Spec. 2.1+EDR stack does not require 4 or 6 digits PIN digits
entry
To Next Page
Loading...
