KDC User Manual SYNCHRONIZATION
148
Toggle key
The UHF tag read mode is toggled between Single read and Multiple read by keep pressing
SCAN button for 3 seconds during UHF Tag read mode.
Trigger
There are two ways of reading UHF tag: Hardware and software trigger. Hardware trigger is
a SCAN button and Software trigger is a API called from application via SDK.
Timeout
KDC470/475 have following UHF tag reading timeout options. KDC470/475 generate 2 short
beeps upon timeout reaches.
• 0.5 second
• 1 second
• 2 seconds
• 5 seconds
• 10 seconds
• Continuous
Data type
KDC470/475 only send EPC data to the host by default but send along with PC data if user
configures by reading below barcodes. Data type also can be changed using SDK.
Data Type – EPC Data Type - PC+EPC
To Next Page
Loading...
