KDC User Manual BLUETOOTH
55
card face to the KDC500.
3. The KDC500 will send the MS card data to the paired host application and the user will hear
a short beep if it has been read successfully.
Read Integrated Chip (IC) Card(KDC500)
1. The paired host application sends a command to enable the IC Card Reader.
2. Insert IC Card into the IC Card slot located in the left side of KDC500. Make sure the IC of
the card face to up.
3. The KDC500 will send the IC card data read to the paired host application.
Synchronizing data to the host device
Use the KTSync
program to synchronize barcode data from the KDC to the host device. Please
refer to Chapter 5. Synchronization for details.
To Next Page
Loading...
