KDC User Manual BLUETOOTH
56
3.3 KDC Device Driver and Firmware
Upgrading KDC Firmware
Requires: Windows PC, USB cable, KDC driver, KDC firmware application.
1.
Download KDC driver at: https://www.koamtac.com/downloads/drivers/
•
Extract the folder, run Setup.exe only.
•
Follow the instructions on the installation wizard.
Note: Once it is installed before, you can skip this step.
2.
Download KDC Firmware at: https://koamtac.com/downloads/firmware/
•
Choose your KDC model & its KDC firmware.
•
Extract the folder, open the KDC firmware upgrade application.
NOTE: Or download the KDC firmware from the link that Koamtac provides.
3.
Confirm the KDC Driver installed properly.
•
Plug in KDC to PC via USB.
•
Navigate to Device Manager [Start > Control Panel > System and Security >
System
> Device Manager].
•
Click on Ports (COM & LPT). The KDC should be listed as
Koamtac Data
Collector
.
4.
In the upgrade application, click ‘Step 1: Select Serial Port’
•
Make sure
all
programs are closed & KDC is not connected to any device via Bluetooth.
•
This should automatically detect the COM port the KDC is using.
•
If a blank dropdown appears, plug the KDC into a different USB port.
5.
Click ‘Step 2: Check KDC’
To Next Page
Loading...
