KDC User Manual BLUETOOTH
94
⚫ Data Time Type
• Changing the “USB Mode” option will erase all data in KDC memory.
Make sure to back up your data before changing this option.
• KTSync may not recognize the KDC if the KDC is in “USB DISK” mode or “USB HID”
mode.
NFC Config Menu – KDC350N/411N/415N/421N/425N/500
NFC Power
⚫ Turning NFC Power on or off
⚫ Options: Enable/Disable
Data Format
⚫ Options: Data only/Packet data.(KDC500 doesn’t support)
UID Only
⚫ Enable or Disable UID Only menu
⚫ The KDC only sends UID data to the host device when the KDC is in UID Only mode.
⚫ (KDC500 doesn’t support)
UHF Config Menu – KDC450U
UHF Power
⚫ Turning UHF Module Power On or Off
⚫ Options: Enable/Disable
Power On Time
Specify the power on time duration of UHF module.
⚫ Options: 500ms/1sec/1.5sec/2sec/2.5sec/3sec/3.5sec/4sec/4.5sec/5sec
Power Off Time
Specify the power off time duration of UHF module.
⚫ Options: 500ms/1sec/1.5sec/2sec/2.5sec/3sec/3.5sec/4sec/4.5sec/5sec
Power Level
Specify the UHF module power level to determine the power strength of antenna. 7 means the
most power strength.
⚫ Options: 0/1/2/3/4/5/6/7
To Next Page
