KDC User Manual BLUETOOTH
114
Auto Power Off
The Auto Power Off option works in conjunction with the PWR Off Time option. This option
Enables the KDC to power off Bluetooth automatically when the KDC is NOT CONNECTED to
the host for the time duration specified in the PWR Off Time option. KDC500 doesn’t support
this option.
The default for this option is disabled. It is strongly recommended to keep it enabled to
maximize the operation time of the KDC. If Auto Power Off is Enabled, Bluetooth may be
manually powered off before the specified time in the PWR off time option.
It is recommended to enable ‘Auto Power On’ option if this option is enabled. User doesn’t
need to turn on the Bluetooth power manually with this configuration.
Beep Warning
The KDC beeps to warn user to power off the Bluetooth if this option is enabled with five short
beeps when the following condition meets..
1. Bluetooth power is ON
2. KDC is disconnected
3. Auto Power Off is DISABLED
KDC500 doesn’t support this option.
PWR OFF Time
The PWR Off Time option works in conjunction with the Auto Power Off option. If Auto Power
Off is Enabled, the KDC powers off Bluetooth when the duration of time specified in the PWR
Off Time option is met and the KDC is NOT CONNECTED to the host. The time setting for
this option is from one (1) minute to 30 minutes. The default is five (5) minutes. KDC500 doesn’t
support this option.
PowerOFF Msg
The KDC sends a Bluetooth power off message “BTOFF” to the host when KDC is connected
from host if this option is enabled. KDC500 doesn’t support this option.
MAC Address
The user may verify the KDC Bluetooth MAC Address.
FW Version
The user may verify the KDC Bluetooth firmware version in this menu.
To Next Page
Loading...
