KDC User Manual SYNCHRONIZATION
160
is not selected.
Beep while Synchronization
The user may enable or disable the beep tone during the synchronization process. If this option
is selected, a beep is sounded every time barcode data is synchronized. The KDC beeps 5 times
when the synchronization process is complete.
Append Data to File
If the user has specified a file name and Append data to File option is enabled, KTSync will
append data to the existing file instead of creating a new file.
Current KDC Wedge Method
The KDC may be configured in one of five wedge/store modes:
⚫ Wedge Only - Scanned data is transmitted to the host. The KDC does not store
scanned data.
⚫ Wedge & Store - Scanned data is stored in the KDC and transmitted to the host.
⚫ Store Only - Scanned data is stored in the KDC but NOT transmitted to the host.
⚫ Save if Sent - Scanned data is stored in the KDC ONLY if transmission to the host is
successful.
⚫ Save if Not Sent - Scanned data is stored in the KDC ONLY if transmission to the host is
unsuccessful.
Enable Wedge (Handheld Scanner Mode)
This option will be checked if Wedge Only or Wedge & Store option is selected.
Keep Scan Data in KDC
This option will be checked if Store Only or Wedge & Store option is selected.
Synchronization Options
Synchronize KDC Time with PC Time when Connected
This option enables the user to synchronize the KDC date and time with the host date and time.
Synchronization of date and time occurs after the data is uploaded to the host device.
Delays
The user may set transmission delays between barcodes and characters during the
synchronization process. It is important to set proper delays to prevent errors during the
To Next Page
Loading...
