KDC User Manual BLUETOOTH
60
3.4 KDC Beep Sounds
The KDC beep sound can be change using a special bar code, using the KDC menu, or using
KTSync.
The beep sound can be turned off entirely by disabling the Beep Sound.
• KDC Menu > System Config > Beep Alert > Beep Sound > Disable > Save & Exit.
Alternatively, beeps can be toggled individually for the following:
• Beep on powering up
• Beep on connection to host device
• Beep on scanning (success & failure)
• (MSR) Beep on card swipe
• (RFID) Beep on RFID tag reading
The beep pitch can be toggled using the Beep Volume(Tone) settings.
• Set to
Low
by default, can be changed to
Low, High
.
• Set to
High
by default for KDC500 only, can be set to
Low, High
.
For the KDC350 and KDC500, the Key Tone refers to the sound from a keypad press.
• KDC350: Set to
Disabled
by default, can be changed to
Disabled, Low, Medium, High
.
• KDC500: Set to
High
by default, can be changed to
Disabled, Low, Medium, High
.
To Next Page
Loading...
